Need help?Do you have a question about the HELIX PP50 DSP and is the answer not in the manual?
General| Channels | 5 |
|---|---|
| Amplifier Class | Class D |
| DSP Resolution | 64 Bit |
| Input impedance | 13 kOhms |
| Damping factor | > 100 |
| Fuse | 25 A |
| Max. Power per channel @ 4 Ohms | 50 Watts |
| DSP Power | 295 MHz |
| Input voltage | 6V |
| Frequency response | 10 Hz - 22 kHz |
| Signal-to-noise ratio digital input | > 108 dB |
| Operating voltage | 10.5 - 16 V |
| Additional features | USB |
| Signal-to-Noise Ratio | >100 dB |
| Weight | 2.0 kg |
Instructions to prevent damage during installation and ensure proper function and warranty coverage.
Guidelines for connecting the HELIX PP50 DSP amplifier, including negative ground system and cable usage.
Steps for connecting the PP50 DSP to the vehicle's radio using harness and adapter options.
Details on powering the unit via vehicle harness or direct battery connection.
Requirements before using the interface and PC Tool, including software and driver installation.
To Next Page
