HELIX P ONE MK2

19
en
Mono subwoofer application
Subwoofer with one voice coil (single voice coil)
RMS output power ≤ 1% THD+N:
1 x 4 Ohms: 500 Watts
1 x 2 Ohms: 880 Watts
1 x 1 Ohm: 1,500 Watts
Note: The crossover frequencies for the high- and lowpass must be set in the preconnected
DSP / DSP amplier.
Parallel operation
Two subwoofers with one voice coil (single voice coil) or
one subwoofer with dual voice coil are connected in parallel.
Note: The parallel connection of two voice coils will result in
halving the impedance!
RMS output power ≤ 1% THD+N:
Two subwoofers with 1 x 4 Ohms correspond to a total
impedance of 2 Ohms: 880 Watts
One subwoofer with 2 x 4 Ohms also corresponds to a total
impedance of 2 Ohms: 880 Watts
Two subwoofers with 1 x 2 Ohms correspond to a total
impedance of 1 Ohm: 1,500 Watts
One subwoofer with 2 x 2 Ohms also corresponds to a total
impedance of 1 Ohm: 1,500 Watts
Note: The parallel connection of 1 Ohm voice coils will re-
sult in shutdown of the amplier.
One subwoofer with
dual voice coil
Two subwoofers with
single voice coil
Conguration examples