HELIX P ONE MK2

22
Technical Data
The warranty service is based on the statutory
regulations. Defects and damage caused by over-
load or improper handling are excluded from the
warranty service. Any return can only take place
following prior consultation, in the original packag-
ing together with a detailed description of the error
and a valid proof of purchase.
Technical modications, misprints and errors ex-
cepted! We accept no liability for damage to the
vehicle or device defects caused by the incorrect
operation of the device. This product has been is-
sued a CE marking. This means that the device is
certied for use in vehicles within the European
Union (EU).
Warranty Disclaimer
Power RMS ≤ 1% THD+N
- @ 4 Ohms ..................................................................1 x 500 Watts
- @ 2 Ohms ..................................................................1 x 880 Watts
- @ 1 Ohm .................................................................... 1 x 1.500 Watts
Max. output power per channel* ................................... Up to 1,800 Watts RMS @ 1 Ohm
Amplier technology .....................................................Class D
Inputs ............................................................................ 2 x RCA / Cinch
1 x Optical SPDIF (28 - 96 kHz)
1 x Remote In
Input sensitivity ............................................................. RCA / Cinch: 0.5 V - 8 V
Input impedance ........................................................... RCA / Cinch: 20 kOhms
Outputs ......................................................................... 1 x Speaker output
Signal converter for the digital input .............................BurrBrown 32 Bit DA converter
Frequency range ..........................................................21 Hz - 40,000 Hz
Subsonic lter ............................................................... 21 Hz / Butterworth 48 dB/Okt.
Signal-to-noise ratio (A-bewertet) ................................. Digital input: 110 dB
Analog input: 110 dB
Distortion (THD) ............................................................< 0.01 %
Damping factor .............................................................> 450
Operating voltage .........................................................10.5 - 17 Volts (max. 5 sec. down to 6 Volts)
Idle current....................................................................1500 mA
Fuse..............................................................................4 x 30 A LP-Mini-fuse (APS)
Power rating .................................................................DC 12 V 160 A max.
Ambient operating temperature range ..........................-40 °C to +70 °C
Additional features ........................................................ Input mode switch, SPDIF Direct In switch,
Start-Stop capability
Dimensions (H x W x D) ...............................................50 x 260 x 190 mm / 1.97 x 10.24 x 7.48”
* In typical applications as subwoofer amplier