WATER BOTTLE HOLDER INSTALLATION
STEP 13:
Find the two bolt holes with bolts pre-installed in the Center Upright Post and remove those bolts (Figure #1)
Once bolts holes are empty (Figure #2) hold the water bottle holder up to the post as shown and install a bolt in
the lower hole in the water bottle holder bracket (Figure #3) and through to the lower bolt hole on the upright.
Do not tighten at this time.
Tilt the water bottle holder upright to align the top hole in the bracket with the top hole on the center upright
post. Install a 2nd bolt into that hole and then tighten with the allen key as shown in Figure #4.
- 13 -
3/ ASSEMBLY - COVER AND HANDLE BARS
1
2
3
4
To Next Page
Loading...
