OVERHEATING SAFETY DEVICE
To prevent damage and risks due to overheating, the built-in overheating safety device cuts off the power
as soon as the heating elements become too hot.
- If this should happen first ensure that it was not the thermostat which has switched off the heater.
Set the thermostat to maximum position.
- If the heater does not switch on, the safety device has been activated.
- Remove the mains plug from the wall socket.
- Let the heater cool down for 15-30 minutes.
- Check if the heater had been placed correctly. Check if anything is obstructing the air flow. If
necessary, clean the grilles with a vacuum cleaner. Replace the plug into the wall socket and
switch the heater on again.
- If the safety device again switches off the heater, remove the mains plug from the wall socket
and have the heater inspected by the manufacturer.
CLEANING
The heater requires regular cleaning to ensure trouble free operation:
Unplug the heater from the mains supply before cleaning.
Ensure that the heater has been allowed to cool before cleaning.
Use a damp cloth (not wet) to wipe the exterior of the heater to remove dust and dirt.
Do not allow any water or other liquid to enter the housing or control panel.
Ensure the heater is dry before plugging back into the mains supply.
CAUTION: Do not use harsh detergents, chemical cleaners or solvents as they may damage the
surface finish of the heater.
Warning: In order to avoid overheating, do not cover the heater.
WARNING - Fabric, clothing or other flammable materials may ignite if placed against or in close
proximity to the heater. No flammable materials should be placed near the heater. Do not cover
the heater. This appliance is for indoor use only. Do not use outdoors.
SPECIFICATIONS
Ceramic
Oscillating Fan
Heater 1500W
To Next Page
