SETTING THE WEEKLY PROGRAM (ONLY BY REMOTE CONTROL)
The current time must be set before any programming.
• Press to switch on the appliance.
1. Press P to enter into weekly program setting (the light P is on).
2. Press DAY to set the day of program activation (d1, d2,d7...).
3. Press EDIT to set the time period number (P1, P2,...P6).
4. Press TIME/ON to set the turn-on time (00, 01, 02 ..., 24) .
Cannot set to minutes.
5. Press TIME/OFF to set the turn-off time (00, 01, 02,..., 24)
Cannot set to minutes. TIME/OFF cannot be less than TIME/ON.
6. Press + or - to set the setting temperature of this time period.
7. Press OK to confirm the setting.
8. Repeat steps 3 to 7 to set another time period number for the same day.
Up to 6 programs are available for each day of the week.
9. Repeat steps 2 to 8 to set the others days of the week.
• Press P to active the weekly program (the light P is on), or to disable it (the light P is off).
• After the above setting are completed and P program is active, press DAY / EDIT TIME/ON and
TIME/OFF to check the setting time of each day and time period.
• When the timer on time is same as the timer-off time, the appliance is in standby mode.
• If the setting temperature is not set, the default setting temperature is 23°C. If room temperature
higher 23°C, the appliance is not switch on.
• The weekly program is erased when the power switch is off.
For example: Setting Monday 1
st
period working time 7:00 to 13:00
Press P Day EDIT Time/On Time/Off OK
SET OPEN WINDOW (ONLY BY REMOTE CONTROL)
It means energy-saving mode. When the product detects a temperature drop of 5-10°C within 10
minutes after opening the window detection function, the product will stop heating within 30
minutes and continue to enter the standby state.
• Press to switch on the appliance, heating for a moment
until stability.
• Press to active the open window mode (the light is on).
• Press + or - to set the setting temperature for the open windows function.
• Press to disable the open window mode (the light is off).
The appliance will resume to previous working mode.
During open window mode, if the room temperature drops from about 5°C to 10°C in less than 10
minutes, the appliance will stop working and enter into standby mode. Press again to switch
on the appliance.
To Next Page
Loading...
Need help?
General
