the length of the bare parts should be 10 mm.
4. Mount the fan heater to the wall . Make sure the two holes located on the back of the heater do
aim at the above two screws, then push the heater backwards to the wall, and then downwards
till the unit is stable.
THE CONTROLS
ON/OFF
Press the ON -OFF switch to switch the appliance ON (I) or OFF (O). the LCD initial screen display is
“－－”
= Heating on half power (1000W)
= Heating on full power (2000W)
= Timer (Turn-on/Turn-off)
OPERATING INSTRUCTIONS
The appliance is suitable for providing auxiliary heating. It is not suitable for use on its own to heat large
spaces.
Ensure that there is sufficient distance from the wall. Fixtures and other appliances. The distance must
be least 1m at the front of the heater to exclude the risk of fire.
Regular function operation
Temperature setting and ErP function
Confirm
Weekly time & window open
detection operation
NOTE: Before inserting the plug into an electrical outlet, make sure that the electrical supply in your area
matches that on the rating label on the unit.
NOTE: It is normal when the heaters are turned on for the first time or when they are turned on after
having not been used for a long period of time, the heaters may emit some smell and fumes. This will
disappear when the heater has been on a short while.
To Next Page
Loading...
