Hello Kitty KT7009A - Setting Default; System Information

17
Turn on the camera, press “Mode” button and select “Configuration” Menu.
Go down to “Light Freq.”, select between “50Hz” and “60Hz” light frequency.
Setting Default
The camera settings can restore to factory default by following steps:
Turn on the camera, press “Mode” button and select “Configuration” Menu.
Go down to “Default Setting”, press “OK” button to allow camera setting restore to factory default.
System Information
The camera firmware version can be obtained by following steps:
Turn on the camera, press “Mode” button and select “Configuration” Menu.
Go down to “System Info.”, press “OK” button and the camera firmware version will be displayed.