Product Manual Easy
4
3. Use of the control panel
Pressing the On/Off button turns the heater on and off (the green LED light indicates that the heater is on).
Press this button to increase the desired temperature or the time that you want the heater to stay on for.
Press this button to decrease the desired temperature.
Desired value. 5-step scale (green LED light). The set value is saved in the appliance memory.
Measured value. 5-step scale (red LED light).
3.1 Setting the time the heater is on
The heater can be on for two to six hours. The sauna must be turned off with the control
panel when setting the time that you wish the heater to come on for.
To set the time, press the button three times.
The LED light on the bottom indicates that the heater will be on for two hours. To add more
hours, press the button (press once for each hour you wish to add).
When all the LED lights are on, which means the heater will stay on for six hours, you can
press the + button again. This resets the time back to two hours.
The heater will stay on for the maximum of six hours when all five red LED lights
are on.
Once you have set the correct number of hours, wait for approximately 5 seconds for the
LED lights to go off.
The time you have set the heater to stay on will be saved in the appliance memory even if
the power supply to the heater is cut off.
The time the heater will stay on cannot be adjusted when the sauna is in use.
After this, the heater can be turned on by pressing the On/Off button.
The heater can also be turned off before the set time has been reached by pressing the
On/Off button.
Buttons for adjusting temperature and
the time the sauna heater is on.
On/Off green signal LED light
On/Off button
Red and green signal LED lights
indicating the temperature
and the time the heater is on.
HIGH
LOW
HIGH
LOW
SAUNA 6h
Helo
HIGH
LOW
SAUNA 6h
Helo
To Next Page
Loading...
Need help?
General
