INSTALLATION AND OPERATING INSTRUCTIONS
4211-70 G
Rev. 3
5/9/14
R.D. LD
TO PROGRAM A DELAY START
Turn your control on by pressing the power button, in the center of the
control pad. Press the "set" button, directly to the left of the time display
window until your display shows a flashing semi-colon in between
the 4 digits. Example: 00:45.
Use your +/- keys to adjust the time to the desired amount of delay
before the sauna starts. Example: to program an 8 hour and 30 minute
delay you would have display like this: 08:30. At this point you may
simply walk away, (do not turn the control off). The control will time
down for the programmed amount of delay and then start on it's own.
Note: Always remember that if you have the flashing semi-colon in
your time display, you are in the delay start mode. Use the "set" button
to toggle between delay and instant start.
Shower
Sauna (10 - 15 min.)
Shower or swim
Rest (10 - 15 min.)
Relax with juice or water
You liked it?
Do it once again and
you will feel great.
SECTION 8: LIGHT INSTALLATION
SECTION 9: HIGH LIMIT CONTROL (RESET BUTTON)
The sauna heater has a built-in high limit control, which automatically
turns off the heater if the temperature inside the sauna room rises to an
abnormally high level.
The Saunalogic control will display "HL" if the high limit control has shut
the heater off. To restart the heater, let the heater cool, then push the
"On/Off" button on the control panel. If the high limit continually shuts off
the heater, contact a service representative at 1-800-780-4427 for
additional support.
Page 6
The Saunalogic control is
ONLY
capable of operating the
Spectr-Light kit. Spectra-Light kits are available as an accessory
and come with 3 internal color therapy, 2 interior white and
3 exterior white lights. These lights are connected directly to the
CB PK 1 contactor box using wiring harnesses supplied with the
Spectra-Light kit. Once installed the Saunalogic control has three
buttons built in to control the three various light circuits. Special
wiring harness extensions are available to make minor changes
to bulb placement.
Note:
Any other lighting options or packages that are used will
require a separate switching device and additional light distribution
and power circuits to be run.
To Next Page
Loading...
Need help?
General
