EasyManua.ls Logo

Hendi 232569 - Page 11

Hendi 232569
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
EN
5.4.
CONTROL PANEL
Thermostat is located on the control panel, see fig. below
Display Thermostat Lock
Thermostat is adjusted in a range from 1 to 7, which means: Refrigerator: from 0 to 10 °C. Freezer: from -10
to -25 °C. Cooling system is off when in position 0. When turning on the appliance, display shows current
temperature inside the appliance.
5.5. DEFROSTING
Refrigerator is equipped with an automatic defrosting system with default parameters.
Freezer requires manual defrosting. We recommend defrosting the frezer every three months or if the ice lay
-
er exceeds 5 mm. Do not use metal or sharp instruments to remove ice from the chamber as it may damage
the appliance.
1. Disconnect the freezer
2. Empty freezer
3. Leave the freezer with the door open
4. Place a tray in the bottom of the cabinet to collect defroste water
5. Clean the freezer with mild detergent and wipe thoroughly
6. Connect the frezer – it is ready for use.
It is recommended to clean the external housing of the appliance and internal part of the door, especially near
the gasket.
5.6. ALARMS
alarm code error
EE Cabinet sensor is defective
- Malfunction of the thermostat
HH Temperature is over the limit
LL Temperature is below the limit