Hendi 232569 - Intended Use; Before the First Use

7
EN
3. INTENDED USE
Cooling appliances are designed for short-time
storage of food at a lower temperature for display
to the customer.
Freezing appliances are designed to store fresh
food with an extended best before date - even for
several months, depending on the type of food and
storage temperature.
This appliance is designed for use in restaurants,
canteens, and commercial enterprises such as
bakeries, supermarkets, etc.
• This appliance is designed for commercial use.
• This appliance is intended for indoor use.
• Use the appliance only as described in the man-
ual.
• Any other use may lead to damage to the appli-
ance, other user property, or personal injury.
• No liability will be accepted for damage resulting
from improper use or non-compliance with this
manual.
NOTE: PRODUCTS PUT TO THE REFRIGERATING/
FREEZING APPLIANCE MUST BE PRECOOLED/
PREFROSTED AND/OR PUT INSIDE CLOSED
CONTAINER FOR FOOD STORAGE. OTHERWISE,
MOISTURE EVAPORATING WHILE COOLING
FOOD PRODUCTS CAN CONDENSATE INSIDE THE
COOLING CHAMBER. WHICH MAY CAUSE CON
TAMINATION OF OTHER PRODUCTS.
Do not store any medications in the appli-
ance.
Operating the appliance for any other pur-
pose means misuse of the appliance.
4. BEFORE THE FIRST USE
4.1. TRANSPORT
• Special package box is required for the delivery of
the equipment. Keep the equipment level during
transportation and handling.
• Please carefully check the package box after re-
ceiving the product to ensure that the equipment
is not damaged during transportation.
• Check for the completeness of the equipment. In
case of incomplete delivery and damages. Please
contact supplier (See == > Warranty).
• When removing the package box, carefully move
away the wood plate in case of scratch the equip-
ment.
• In case that the equipment tilts during the trans-
portation and handling, the lubricant in the com-
pressor may flow into the cooling loop. Therefore,
in order to ensure the lubricant flows back to the
compressor, it is necessary to keep the equipment
level for 24 hours before plug in the equipment
and starts to work.
• Do not throw away the package randomly. Please
dispose as per relevant local rules and regula-
tions.
• Clean all components as described (See == >
Cleaning and Maintenance).
• Place all the shelves inside the appliance.
NOTE: Due to manufacturing residues, the appli-
ance may emit a slight odor in the first few cycles.
This is normal and does not indicate any defect or
hazard. Make sure the appliance is well ventilated.
• Turn on the lighting switch, check the light is nor-
mal.
• The digital temperature controller is delivered
with default parameters. Do not alter the param-
eters casually except for special need.
• When running for the first time, it should run
without load for 2 hours to ensure the refriger-
ation system is working normally. Only when the