Suitable
Not suitable
Bottom of cookware
Flat bottom
Curved, uneven, rounded bottom
Material
Cookware with iron, cast iron,
magnetic stain- less steel or
enamelled iron bottom.
Cookware with ceramic, glass, copper, bronze, or aluminium
bottom.
Diameter of the
bottom
Between 12 cm and 26 cm. Less than 12 cm or more than 26 cm.
Type of cookware
Cookware with a bottom thickness
over 1.5 mm.
Completely closed containers or cans.
Note: Using a pan or pot that’s not suitable for induction cooking may damage the appliance.
Operation
Place a suitable cookware at the centre of the heating surface of the appliance. (See –> Suitable cookware for the appliance).
Note: Do not place empty cookware as this may damage the cookware.
Connect the power plug to a suitable electrical supply outlet.
Then, switch ON the appliance by turning the knob (2) in clockwise direction.
“ON” will be shown instantly on the display (1).
Next, choose the power level by turning the knob (2) clockwise.
Minimal setting is 500W which increases in steps of 100 W to the maximum setting of 3500 W for item 239780 or 3000W for item
239315.
Now, the appliance starts heating operation. The set power will be shown on the display (1) during cooking.
After cooking finished, you can turn off the appliance at any time by turning the knob (2) anti-clockwise. “OFF” will be shown on
the display (1) for few seconds and then go off.
Note:
1. After an extended period of operation, it is normal for the cooling fan inside to continue running in OFF mode for some time.
Before unplug the appliance, wait until the cooling fan stops running.
2. The appliance’s surface is still hot even after switch to OFF mode. Please wait the appliance completely cool down before
touching or cleaning.
3. If no cookware is placed on the heating surface after switch ON, it will turn to OFF mode automatically within 1 min.
4. If no any button on the control panel is pressed during operation for 2 hours, the appliance will then switch to OFF mode
automatically.
5. If the appliance beeps after being switched on, the pan you are using is not suitable for induction or the appliance is defective. In
case of any doubt, always contact the supplier of your pan!
Error codes display
To Next Page
Loading...
