Error codes shown on the display (1) Possible cause Possible solution
E01
The temperature of the appliance is too high
Unplug the appliance, remove the
cookware, wait until the appliance is
completely cool down.
Cooling fan defective Contact the supplier.
E02
The temperature of the cookware is too high.
Possibly, the cookware becomes empty and
appliance will shut down for protection.
Unplug the appliance, remove the
cookware, wait until the appliance is
completely cool down.
E03
The supply voltage is abnormal. (Supply volt- age is
too high or too low)
Make sure that the appliance is
connected to a suitable electrical
power supply.
Cleaning and Maintenance
Attention: Always unplug the appliance from the electrical power outlet and let it cool down completely before cleaning and storage.
Cleaning
Never immerse the appliance in water or other liquids.
Clean the cooled exterior surface with a slightly damp cloth or sponge with some mild soap solution.
Never use abrasive sponges or detergents, steel wool or metallic utensils to clean the interior or exterior parts of the appliance.
Storage
Before storage, always make sure the appliance has already been disconnected from the electrical outlet and cooled down
completely.
Store the appliance in a cool, clean and dry place.
Never put heavy objects on the heating surface during storage as it may crack it.
Troubleshooting
If the appliance does not function properly, please check the below table for the solution. If you are still unable to solve the problem,
please contact the supplier/service provider.
Error codes shown on the digital display (1). (See –> Error codes display)
To Next Page
Loading...
