Why is my Henny Penny Fryer shortening not heating?
If your Henny Penny Fryer is not heating, first check if the drain valve is open and close it. If that's not the issue, the high-temperature limit may have tripped. In this case, reset the high-temperature limit; see Operating Components Section.
Why pressure does not build in Henny Penny Fryer?
If the pressure isn't building in your Henny Penny Fryer, several factors could be at play. Ensure you're using a full capacity of product in the frypot when using fresh shortening. Check that the metal shipping spacer has been removed from the deadweight assembly; see Unpacking Instructions Section. Verify the pressure is correctly programmed. Lastly, inspect the lid gasket for leaks and reverse or replace it if needed.
What to do if Henny Penny Fryer is foaming or boiling over?
If your Henny Penny Fryer is foaming or boiling over, follow the boil-over procedures from the chart.
What to do if filter motor won’t run in Henny Penny Fryer?
If the filter motor on your Henny Penny Fryer won’t run, it might be overheated. Try resetting the motor; see Filter Pump Motor Protector-Manual Reset Section.
How to fix shortening not draining in Henny Penny Fryer?
If the shortening isn't draining from your Henny Penny Fryer, it's likely that the drain valve is clogged. To resolve this, push a cleaning rod through the open drain valve.
What to do if my Henny Penny Fryer shows 'E05'?
If the Henny Penny Fryer displays 'E05', it indicates the shortening is overheating. First, turn the switch OFF, then back ON. If the error persists, have the heating circuits and temperature probe checked. After the unit cools down, the controls should return to normal. If 'E05' continues, the controls may need replacement.
What to do if my Henny Penny Fryer shows 'E06'?
If the Henny Penny Fryer displays 'E06', it means there is a temperature probe failure. Turn the switch OFF and then back ON. Have the temperature probe checked, and repair or replace it. Once the temperature probe is repaired or replaced, the controls should return to normal. If 'E06' persists, the controls may need replacing.
What to do if my Henny Penny Fryer shows 'E04'?
If the Henny Penny Fryer displays 'E04', it indicates the control board is overheating. Turn the switch to the OFF position, then back to ON. If the display still shows 'E04', check for signs of overheating behind the control panel. Allow the panel to cool down, and the controls should return to normal. If 'E04' persists, the control may need to be replaced.
What to do if my Henny Penny Fryer shows 'E41'?
If the Henny Penny Fryer displays 'E41', it signals a programming failure. Try turning the switch OFF, then back ON. If the display continues to show 'E41', re-initialize the control (see programming section). If the error code persists, the control panel may need replacement.
How to troubleshoot Henny Penny Fryer when power switch is on but fryer completely inoperative?
If your Henny Penny Fryer is completely inoperative even when the power switch is on, there may be an open circuit. Ensure the fryer is plugged in and check the breaker or fuse at the wall.
General| Model | PFE-592 |
|---|---|
| Category | Commercial Food Equipment |
| Type | Pressure Fryer |
| Capacity | 14 lb (6.4 kg) food |
| Oil Capacity | 6.5 gal (24.6 L) |
| Power | 5.5 kW |
| Weight | 490 lb (222 kg) |
| Computer Controls | Yes |
| Voltage | 208V/240V |
| Phase | 3 |
To Next Page