Page 9Item 56932
6. Before beginning work, provide for sparks
and debris that will fly off the work surface.
General Operation
1. Make sure that the Switch is in the
off‑position, then plug in the tool.
2. Turn Power Switch to ON position.
Squeeze the Trigger to start tool.
3. Allow tool to come up to full speed
before touching the work surface.
4. Apply the accessory to the work surface,
allowing tool to operate at full speed. If
tool bogs down, use lighter pressure.
5. To create a smoother surface,
keep the accessory moving over the work surface.
6. Slide the switch to OFF “O” position to stop tool.
7. Allow tool to come to a complete
stop before setting it down.
8. To prevent accidents, turn off tool and disconnect
its power supply after use. Clean, then
store tool indoors out of children’s reach.
Grinding and Wire
Brushing Instructions
1. Make sure that the Switch is in the
off‑position, then plug in the tool.
2. Turn Power Switch to ON position.
Squeeze the Trigger to start tool.
3. Allow tool to come up to full speed
before touching the work material.
4. Apply the wheel to the work material at a 10° –
15° angle, allowing tool to operate at full speed.
If tool bogs down, use lighter pressure.
5. To create a smoother surface,
keep the tool moving over the work surface.
6. Slide the switch to OFF “O” position to stop tool.
7. Allow tool to come to a complete
stop before setting it down.
8. To prevent accidents, turn off tool and disconnect
its power supply after use. Clean, then
store tool indoors out of children’s reach.
Polishing Instructions
1. Wash the work surface thoroughly, and
make sure it is free of dust, dirt, oil, grease, etc.
2. Place a clean Foam Pad (sold separately)
securely onto the Backing Pad.
2. Apply about two tablespoons of wax
(not included) evenly on the clean Foam Pad.
Do not apply the wax directly to the surface
of the vehicle. The amount of wax needed will vary
according to the size of the vehicle being waxed.
Only use slower speeds for polishing.
Otherwise, damage may occur to the paint
being polished. Harbor Freight Tools is not
responsible for damage to the vehicle’s
finish due to improper use of this tool.
3. Make sure that the Switch is in the
off‑position, then plug in tool.
Start and stop tool only while it is
held firmly against the surface of the vehicle.
Failure to do so may result in the Foam Pad or
Polishing Bonnet being thrown from the Polishing Pad.
4. Turn Power Switch to ON position.
Squeeze the Trigger to start tool.
5. Allow tool to come up to full speed
before touching the work material.
6. Keep pressure off of tool when operating.
The Foam Pad should LIGHTLY
contact the polishing surface.
To prevent damage to the foam pad,
polishing bonnet, and vehicle finish:
Only apply the pad/bonnet flat against the surface.
7. Begin using tool to apply wax to the
vehicle. Apply the wax to all flat surfaces
with broad, sweeping strokes in a
crisscross pattern. Apply the wax evenly
over the surface of the vehicle.
8. Add additional wax to the Polishing Pad as needed.
To add additional wax:
a. Stop tool and allow tool to come
to a complete stop.
b. Add a small amount of wax evenly
over the pad surface.
c. Avoid using too much wax. For additional
applications of wax to Foam Pad, reduce the
amount of wax. The Foam Pad will not absorb
as much wax in subsequent applications.
d. Resume operation.
To Next Page
Loading...
