Page 6 For technical questions, please call 1-888-866-5797. Item 70068
SETUP – BEFORE USE
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
Functional Description
1. Chuck
2. Work Lights
3. Direction Switch
4. Trigger
5. Mode Indicator / Speed Selection Button
2
1
3
4
5
OPERATION
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION:
Make sure that the Trigger is locked and Battery
Pack is removed before performing any procedure
in this section.
Charging Battery Pack
Charge battery after unpacking and before using this
tool. Follow instructions included with battery charger.
Attaching Belt Clip, Bit Holder, and Lanyard
1. Attach Belt Clip to either side of the
tool using supplied Screw.
2. Attach Bit Holder to the other side
using supplied Screw.
Screw
Belt Clip
Bit
Holder
Screw
3. Attach Lanyard (sold separately) to the
Lanyard Loop on the Handle.
Lanyard
Loop
To Next Page
Loading...
