Page 7For technical questions, please call 1-888-866-5797.Item 58966
9. WHEN WET VACUUMING:
WARNING! TO PREVENT SERIOUS INJURY
FROM ELECTRIC SHOCK:
Dry your hands and feet before touching
plug or switch.
Do not continue to use the vacuum when the tank is
full of liquid.
Do not plug in power tool while wet vacuuming.
10. Make sure Automatic Filter Cleaning is off.
IMPORTANT! Leave a gap at the tip of
the nozzle opening to allow air inflow.
Do not immerse the nozzle completely in liquid.
When the Motor sound becomes
higher in pitch, the Tank is full and
the float is closing off the motor intake.
IMMEDIATELY:
a. DRY YOUR HANDS AND FEET,
b. Turn the Vacuum OFF,
c. Unplug the Power Cord,
d. Empty the Tank:
11. To prevent accidents,
DRY YOUR HANDS AND FEET,
turn off the appliance and unplug it after use.
Empty and clean Tank, dry Tank,
clean Filter (see Cleaning Filters on page 7),
then store the appliance indoors
out of children’s reach.
USER-MAINTENANCE
AND STORAGE
Procedures not specifically explained
in this manual must be performed
only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM
ACCIDENTAL OPERATION:
Turn the Power Switch of the appliance off and
unplug the appliance from its electrical outlet
before performing any procedure in this section.
TO PREVENT SERIOUS INJURY
FROM APPLIANCE FAILURE:
Do not use damaged equipment.
If abnormal noise or vibration occurs, have
the problem corrected before further use.
Cleaning, Maintenance,
and Lubrication
1. BEFORE EACH USE, inspect the
general condition of the appliance. Check for:
• loose hardware
• misalignment or binding of moving parts
• air leakage on the Tank or Power Head connection
• cracked or broken parts
• damaged electrical wiring
• any other condition that may
affect its safe operation.
2. AFTER USE, wipe external surfaces of
the appliance with clean cloth. Store in an
indoor dry area out of reach of children.
3. All parts are permanently lubricated.
Do not use additional lubrication.
4. WARNING! TO PREVENT SERIOUS
INJURY: If the supply cord of this appliance
is damaged, it must be replaced only
by a qualified service technician.
Cleaning Filters
To ensure proper operation, clean the Filter
regularly. Torn Filter should be replaced.
1. Remove Filters.
2. Tap or shake Filters into a waste can.
3. If needed, flush with plain water. Allow the
Filter to dry for at least 24 hours before
replacing. DO NOT USE COMPRESSED AIR.
WARNING! TO PREVENT SERIOUS INJURY:
Installing a wet Filter will increase the risk of
electric shock and may damage the vacuum.
4. Replace Filters.
To Next Page
Loading...