ATTENTION! Before working on electrical parts be
sure the appliance has been disconnected from
the mains.
In order to replace the fans, observe the following
instructions:
1. Remove t he four screws holding the front
of the fan support tray (Fig.1).
FIG. 1
2. Once the 4 screws have been loosened remove
the fan support tray (Fig. 2). Be especially careful
when removing the tray so as not to cut or
damage the wiring.
FAN
SUPPORT TRAY
FIG. 2
INDUSTRIAS HERGÓM, S.A., rejects any liability
derived from a faulty installation or incorrect use
and reserves the right to alter its products without
prior warning.
Any liability due to manufacturing defects will
be subject to the criteria and verification of the
company’s experts and will be limited to the repair
or replacement of its products, excluding any
construction work or damage the said repairs may
cause.
2.2 DISMANTLING THE VENTILATOR
To Next Page
Loading...
