Need help?Do you have a question about the Hertz marine HCP 1MDK and is the answer not in the manual?
General| Channel Mode | Mono |
|---|---|
| Test Voltage | 14.4 V |
| Output Power (RMS) @ 1 Ohm | 1000 W |
| Output Power (RMS) @ 2 Ohms | 600 W |
| Output Power (RMS) @ 4 Ohms | 380 W |
| Signal to Noise Ratio (A weighted @ 1 V) | 100 dB |
| Input Sensitivity | 0.2V - 6V |
| Remote In | Yes |
| Load Impedance (MIN) | 1 Ohm |
| Signal to Noise Ratio | 100 dB |
| Subsonic | 25 Hz |
| Phase | 0 - 180° |
| Frequency Response | 10 Hz - 500 Hz |
Critical safety advice for installing and using the amplifier to prevent damage or injury.
Step-by-step guide for performing a standard amplifier installation.
Instructions for connecting the power supply, remote turn-on, and managing fuses.
Diagrams and warnings for connecting multiple amplifiers to a single power source.
Detailed technical data for the HCP 1MDK amplifier, including power, dimensions, and filters.
Detailed technical data for the HCP 2MX amplifier, including power, dimensions, and filters.
Detailed technical data for the HCP 4M amplifier, including power, dimensions, and filters.
Detailed technical data for the HCP 4MDK amplifier, including power, dimensions, and filters.
Detailed technical data for the HCP 5MD amplifier, including power, dimensions, and filters.
Detailed technical data for the HCP 5MD-24V amplifier, including power, dimensions, and filters.
To Next Page
