Need help?Do you have a question about the Hertz HCP 2 and is the answer not in the manual?
General safety guidelines and installation best practices for Hertz amplifiers.
Step-by-step guide for installing Hertz amplifiers, covering connection and setup.
Guide for selecting appropriate power and ground cable gauges based on current draw and length.
Instructions for connecting power, remote-on, and replacing fuses for Hertz amplifiers.
Wiring diagram for installing the HCP 1D as a filtered subwoofer amplifier.
Wiring example for the HCP 1D amplifier in a full-range single-channel setup.
Diagram for connecting the HCP 2 amplifier for front left and right speakers.
Detailed technical data for the HCP 1D amplifier, including power, features, and dimensions.
Technical specifications for the HCP 2 amplifier, covering power output, features, and physical details.
Detailed technical data for the HCP 4 amplifier, including power, sensitivity, and filters.
Technical specifications for the HCP 4D amplifier, covering power output, bandwidth, and input options.
Comprehensive technical data for the HCP 5D amplifier, including power, filters, and CEA ratings.
General| Input Sensitivity | 0.6 ÷ 6 V |
|---|---|
| Distortion - THD (100 Hz @ 4Ω) | 0.01% |
| Damping Factor (100 Hz @ 4Ω) | >100 |
| Pre-In | Yes |
| Speaker-In | Yes |
| Remote In | Yes |
| Output Power (RMS) @ 14.4 VDC | 65 W x 2 (4Ω) 95 W x 2 (2Ω) 190 W x 1 (4Ω) |
| S/N Ratio (A weighted @ 1 V) | >90dB |
| Signal-to-Noise Ratio | >90dB |
| Dimensions | 7.5" x 5.5" x 2.1" |
| Channel Mode | 2-channel |
To Next Page
