Need help?Do you have a question about the Hertz HP 2 and is the answer not in the manual?
General| Remote In | Yes |
|---|---|
| Output Power (RMS) @ 14.4 VDC (1 Ch) | 200 W x 1 (4Ω) |
| S/N Ratio (A weighted @ 1 V) | >95dB |
| Pre-In / Speaker-In | Both |
| Frequency Response | 10Hz - 30kHz |
| Signal-to-Noise Ratio | >95dB |
Description of preamplified (PRE IN/OUT) and speaker (SPEAKER IN) input ports.
Details on power supply (+BATT, GND, FUSE), remote (REM), and speaker output terminals.
Details on internal electronic crossover and PRE OUT filter settings for the HP 2 amplifier.
Details on internal electronic crossover settings for A and B channels of the HP 4 amplifier.
Adjusting input sensitivity for maximum undistorted power output.
Description of the dot matrix LCD display, its backlight, and information visualization.
Explanation of LED indicators and their role in diagnosing amplifier status and protections.
Instructions on how to mount the amplifier, including details on mounting holes.
To Next Page
