11
Save a profile
SmartControl allows you to store an unlimited amount of
profiles. In order to save a profile, do the following:
• Click File, then click Save Profile. - Select a folder where you
want to save your profiles.
• Set the desired filename, leave the extension (.xml) as is.
• Click Save.
Load an existing profile
In order to use a previously saved profile, do the following:
• Click File, then click Open Profile.
• Locate the profile, then click Open.
• In order to apply the profile, click Save settings to the pedals
in the Profile tab.
Good to know
All profiles are saved relative to your personal calibration
values. This means that you can exchange pedal profiles with
fellow Sim Pedals Ultimate+ owners and apply them without
re-calibrating.
Profile changes are applied directly onto the Sim Pedals
Sprint controller board. If your simulator software is Alt-TAB
friendly, you can apply a different profile or test specific
adjustments in the middle of a training session.
To Next Page
Loading...