12
Brake only:
• Pedal resistance
• Coil spring preload
Each of the adjustments will be explained in detail below.
Some (not all) of the steps are illustrated by images.
All pedals – pedal angle
You have the option to adjust the pedal angle.
In the default configuration the pedals are slanted backwards
10 degrees. This is a useful position if your seat is relatively
high compared to the pedal area, or if your rig has an angled
base / pedal plate.
The lower your seat is relative to the pedal area, the further
you may wish to angle your pedals forward. A total range of
15 degrees (from -10 degrees to +5 degrees) is available.
Adjusting the pedal angle is done by adjusting the angle of the
pedal body relative to the rear feet. Do the following in order
to adjust this angle:
1. Using the 5mm hex key, remove the 2 bolts which sit in
the small holes in the rear pedal feet (indicated in the image
below). You can take out both bolts at once, the internals of
the pedal will not be affected.
Mechanical
adjustments
Next to SmartControl adjustments, there are
also plenty of mechanical adjustments that
change the feel or ergonomics of your Sim
Pedals Ultimate+.
Overview
The following mechanical adjustments are available:
All pedals:
• Pedal angle
• Pedal plate height
Throle & Clutch:
• Pedal travel
• Overall pedal force
• Pedal spring preload
Clutch only:
• Pedal force curve
To Next Page
Loading...