6
Calibration
SmartControl also includes a calibration wizard. Because your
pedals have been pre-calibrated during assembly, calibration
is not required before first use. Recalibration in SmartControl
is only required when:
1. The mechanical end-stop of the throttle or clutch pedal
has been adjusted.
2. Mechanical adjustments have been made to the brake.
3. If you’ve switched around pedal cables in the controller.
Throle and clutch deadzone adjustment
For the throttle and clutch pedal you can set a bottom and
top deadzone in SmartControl.
• Bottom deadzone: Pedal output starts after a little bit of
movement from the pedal.
• Top deadzone: Pedal output reaches 100% a little bit before
hitting the endstop.
SmartControl adjustments
Your Sim Pedals Ultimate+ come with a
powerful configuration tool allowing you to
set up your pedals in ways not previously
possible: SmartControl.
Download SmartControl
The software can be downloaded from our website
heusinkveld.com. Click on Support (top bar). Scroll to Sim
Pedals Ultimate+. Click on Download SmartControl. Save the
file and run from a folder of your choice.
Overview
With SmartControl you can configure (non-linear) pedal
output curves, set pedal deadzones and the brake pedal
force. All settings can be saved into profiles, which can be
loaded again in a few mouse clicks.
Settings applied in SmartControl will have effect in any
simulator software, without having to make additional
adjustments, re-assign controls or recalibrate (including
iRacing) in the simulator software itself.
To Next Page
Loading...