5
Installing the electronics
Each pedal needs to be connected to the USB-controller
which is included with your pedal set. The controller is the
small box with the metal enclosure with the text ‘Sim Pedals
Ultimate+ SmartControl’ printed on top.
Every pedal has a wire with an RJ-plug at the end. Your Sim
Pedals Ultimate+ are pre-calibrated. Because of this you need
to insert the RJ-plug of each pedal in the correct port on the
controller. The ports on the controller are labelled. If you have
a 2-pedal set without clutch, you can leave the clutch port
empty.
Next, connect the provided USB-cable. One side of the cable
can be plugged into the controller. The other side should be
connected directly to your pc.
Please make sure there always is a bit of slack in the cables.
This prevents damage to plugs, sockets and electronics.
Specifically if you use a motion simulator, secure the USB
cable to the (moving) frame of your simulator before you
connect it to the controller.
Plug & play
Your pedals are now ready for racing. They are pre-calibrated
with a brake force of appr. 80kg and will work after assigning
them in your favourite simulator software. Please note that
iRacing requires an additional one-time in-game calibration:
calibrate all axis to an output of 4095.
Brake Clutch
Throttle
To Next Page
Loading...