21
Maintenance
Your Sim Pedals Ultimate+ have been designed to
have a minimum of wear, tear and noise. In order to
keep your pedals in good shape for many years, we
recommend following these maintenance procedures.
Preventive lubrication - throle & clutch
Most pivot points on the Sim Pedals Sprint have self lubricating bearings.
On the throttle and the clutch there are 3 positions which may however
receive preventive lubrication:
• Bearing in the backplate (rear part of the swingarm, through which the
spring rod runs).
• Both side-bearings of the swingarms.
Please refer to the images on the next page to see the exact location.
The recommended lubricant for the throttle and clutch is PTFE Dry Spray. A
good service interval would be to lubricate every 100 hours of use.
Lubrication - brake pedal
Lubrication of the brake is only required if the brake makes an unwanted
noise. In this case, check if the noise comes from the bearing in the
backplate of the brake (through which the rod runs). If so, apply a bit of
lubricant to this bearing.
The recommended lubricant for your brake pedal is PTFE Dry Spray.
To Next Page
Loading...