What to do if Hewlett Packard Enterprise AF40 temperature is too high?
If the Hewlett Packard Enterprise Storage temperature is too high, the controller will send a warning alert. This prompts the user to take corrective action by checking airflow and cooling.
Lists essential information and settings required for successful NimbleOS setup and array configuration.
Step-by-step instructions for the physical installation of HPE Nimble Storage arrays into a rack.
Illustrates physical network connections for various topologies, connecting management and data ports.
Guide to using the Nimble Setup Manager GUI for initial array configuration and setup.
Procedure for initial array setup via Command Line Interface (CLI) using a serial connection.
Instructions for safely powering off the array and expansion shelves via GUI or CLI.
Procedures to verify array model, OS version, and controller states for maintenance.
Procedure for cabling the expansion shelf to the array and activating it in NimbleOS.
Covers drive maintenance, including failure handling, SSD, and dual flash drive carrier replacement.
Details controller maintenance, including replacement, PCIe card upgrades, and failover operations.
Covers power supply maintenance, including failure identification and replacement of AC or DC PSUs.
Procedures for chassis maintenance, primarily focusing on replacing the entire chassis.
Instructions for adding new SSDs to increase storage capacity in arrays and expansion shelves.
Detailed steps for upgrading array controllers to newer models, with specific procedures for AF20, AF40, and AF60.
General| Model | AF40 |
|---|---|
| Latency | Sub-millisecond |
| Category | Storage |
| Drive Type | SSD |
| Power Supply | Redundant power supplies |
| Data Compression | Yes, inline |
| Data Deduplication | Yes, inline |
| Processor | Intel Xeon |
| Network Interfaces | Ethernet |
To Next Page
