If, after multiple attempts, you are unable to calibrate the compass, Press the “Cancel” button and change
the “Fitness” drop-down to a more relaxed setting and try again.
Radio Control Calibration
Radio Control Calibration
Connect the RC receiver to The Cube via RCIN and turn on your RC transmitter. Verify that the transmitter
is bound to the receiver (the receiver displays a solid green light) and that it is set to use the correct model
for your vehicle.
Open the "INITIAL SETUP > Mandatory Hardware > Radio Calibration" screen. If your RC receiver (Rx) and
transmitter (Tx) are bound, you should see the green bars move when you move the transmitter sticks.
To Next Page
Loading...