5
© HeyCafé Co., LTD. Version 1.0, Dec. 2019
4) UNPACK and INSTALLATION:
Warning: Grinder’s entire technical handling operations such as installation, maintenance, or service
should be performed by certified personnel or by your local dealer.
After opening the box, make sure that the grinder is intact and that there is no visible damage. If there is any
doubt, DONOT use the grinder and call your local dealer for further assistance.
Unpack the carton box carefully. For your convenience we suggest storing all packaging materials where they
can be used in the future, whenever the grinder’s transportation is necessary.
Place the grinder on a stable flat counter in a dry area away from water or water splashes.
Position the coffee residue tray underneath the body in front of the appliance.
Before installing the beans hopper, please take few seconds to identify the beans hopper, silicone ring and
hopper’s locking screw.
Install the beans hopper firmly into its position on top of the body inside the top grindstone holder.
Fasten the hopper to the grinder body by the locking screw. (Fig.4.3) Make sure that the screw is inserted
completely through both holes in the hopper and in the top grindstone holder.
Fig 4.1 Fig 4.2 Fig 4.3
The Hopper locking screw is a SAFETY DEVICE. Before removing the hopper disconnect electric power cord.
Never try to operate the grinder if the beans’ hopper is not fully secured in its position.
Before plugging in the electrical cord, make sure:
o The grinder voltage and frequency rating (according to the bottom cover label) is the same as the
supply mains.
o The wall socket is fitted with an efficient ground contact. DONOT plug the grinder into the supply
mains if the ground system was not positively checked to be in compliance with current safety rules.
o The power/current consumption of the grinder (according to the backside label) is consistent with the
capacity of the relevant main socket.
o The main socket is protected against short outs and power surges.
o Do not use extension cables, plug adapters for multiple sockets, or make shift connections.
IT IS COMPULSORY TO EARTH THE GRINDER. The manufacturer cannot be held responsible if
this requirement was not complied with.
Plug in the grinder.
Upon first time operation, and before placing beans in to the hopper, VISUALLY check that the grindstone
rotation direction is clockwise by switching the grinder ON for a few seconds.
Should the rotation direction be wrong, do not use the grinder and contact your local dealer for further
instructions.
To Next Page
Loading...
