Both mth2 and mth3 are the same operation, so won't repeat them.
Send save, the module will feedback “received message: save all vars have been
saved”, indicating that the command configuration is successful and the
parameters are saved. If you do not receive this feedback, please check whether the
sending command has a carriage return and line feed, and resend the command.
Send get_all, the module will feedback“received message: get_all” And return all
parameter settings of the current module. If you do not receive this feedback, please
check whether the sending command has a carriage return and line feed, and resend
the command. You can use this command to check whether the parameter settings
of the module are normal: after setting the parameters and sending save, power off
To Next Page
Loading...
Need help?
General
