4. Charging
5. Riding Basics
Open the rubber plug
Always wear a helmet and safty gear so to
avoid falling and injury during the driving
learning,
as shown in the figure.
1. Turn the power on,
and check the electricity indicator.
2. Stand on the base with one foot and propel
yourself with the other foot.
Insert the charging plug in Fill and fix the rubber
plug after the charging
Your scooter will be fully charged when the LED light on the charger changes from red （charging） to green.
After a period of full charge, the charging
will automatically cut off.
Even so, we still don't recommend charging your scooter for long time.
Do not connect the charger if the charging port is wet. Cover the charging port when not use.
3. When the electric scooter begins to glide, put
both feet on the deck and press the accelerator.
The speed shall be kept above 3.1mph (5km/h)
for starting the throttle.
4. Release the throttle and to reduce the speed
slowly. Squeeze the brake lever for a sudden
brake.
5. Tilt your body to the steering direction as you
turn, and turn the handlebar slowly.
5
4
To Next Page
Loading...
