© 2019 - 2020 HID Global Corporation/ASSA ABLOY AB. All rights reserved. HID, the HID Brick logo, the Chain Design, HID Aero, and HID Signo are trademarks or registered
trademarks of HID Global, ASSA ABLOY AB, or its aliate(s) in the US and other countries and may not be used without permission. All other trademarks, service marks, and
product or service names are trademarks or registered trademarks of their respective owners.
hidglobal.com
An ASSA ABLOY Group brand
HID Aero™ X100
Reader Interface
Up to 4 Readers, 7 Inputs, 4 Outputs
PLT-04234, Rev. A.3
INSTALLATION GUIDE
X100 Overview
The X100 has two reader ports, four relays, seven inputs, and one RS-485 port for IO module connection.
Supplied parts
HID Aero X100 reader interface (1)
Installation guide (1)
Mounting screws (4) 0.138" × 1" (3.5 mm × 25 mm)
Recommended parts
(not supplied)
Certified DC power supply
Drill with various bits for mounting hardware
For DIN rail mounting: Brackets (2) - Phoenix Contact,
USA 10 Series Rail Adapter, part number 1201578.
Screws (4) - Self tapping, countersunk,
3.0 mm × 10 mm (or 3.0 mm × 8 mm)
CABLE REQUIREMENTS (NOT SUPPLIED)
Readers - OSDP
4 conductor twisted pair over-all
shield, Belden 3107A or equivalent.
2000 ft (610 m) maximum. Utilize one
pair for data and one pair for power
Readers -
Wiegand / C&D
4-conductor, 18 AWG, shielded, 500 ft
(150 m) maximum
IO Module
One twisted pair, shielded, 24 AWG,
120Ω impedance, 4,000 ft
(1,219 m) maximum
Alarm Inputs
One twisted pair per input,
30Ω maximum, typically 22 AWG,
1000 ft (304.8 m)
Power and Relays
2-conductor shielded
18 to 16 AWG, 500 ft (150 m)
4.53"
(115 mm)
5.51"
(140 mm)
RELAYS 1-4
See step 5.
INPUTS 1-4
See step 4.
INPUTS 1-4
See step 4.
READERS 1-2
See step 3.
Status LEDs
See page 6
POWER, TAMPER, AC FAIL, BATT FAIL
See step 7.
Status LEDs
See page 6
RELAYS 1-4
See step 5.
READERS 1-2
See step 3.
DIP SWITCH
See step 6.
JUMPERS
See step 2.
IO MODULE PORT
See step 2.
To Next Page
Need help?
General
