HID Signo™ Reader Installation Guide
December 2019PLT-03704, Rev. A.1 41
Powering
Trusted Identities
Regulatory
UL
Connect only to a Listed Access Control / Burglary power-limited power supply. These readers are intended to be used
with listed (UL294) control equipment. Suitable for outdoor use.
Only Wiegand, OSDP, and Bluetooth communications have been evaluated by UL.
HID Signo readers are compatible with HID Mobile Access® version 3.0.0 and later using mobile devices with BLE version
4.2 and later listed at: https://www.hidglobal.com/mobile-access-compatible-devices.
Install in accordance with NFPA70 (NEC) Local Codes, and authorities having jurisdiction. Follow all National and Local
Codes.
UL 294 Performance Levels
MODEL #
ACCESS CONTROL
LINE SECURITY
LEVEL
DESTRUCTIVE
ATTACK LEVEL
ENDURANCE LEVEL
STAND-BY POWER
LEVEL
CONDITIONS
20 / 20K / 40 / 40K Level I Level I Level IV Level I
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
CAUTION: Any changes or modifications to this device not explicitly approved by the manufacturer could void your
authority to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Canada Radio Certification
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2)
l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
To Next Page
Loading...
Need help?
General
