Operations
2. Check for a steady flow of water from the cooling water pilot hole.
CAUTION
A continuous flow of water from the cooling water pilot hole shows that the water pump is
pumping water through the cooling passages. If water is not flowing out of the hole at all times
while the engine is running, overheating and serious damage could occur. Stop the engine and
check whether the cooling water inlet on the lower case or the cooling water pilot hole is blocked.
Consult your dealer if the problem cannot be located and corrected.
Shifting
WARNING
Before shifting, make sure there are no swimmers or obstacles in the water near you.
NOTE:
To change the boat direction or shifting position from forward to reverse or viceversa, first close
the throttle so that the engine idles (or runs at low speeds).
Forward
1. Place the throttle grip in the fully closed position.
2. Move the gear shift lever quickly and rmly from neutral to forward .
When
F
N
20
To Next Page
Loading...
Need help?
General
