Hifonics VRX82A - Specifications; Important Notes Prior to Installation

8
Please read the user‘s manual carefully before the installation and the rst operation
of the amplier.
All Specications are subject to change
SPECIFICATIONS VRX82A
Subwoofer
Passive Radiator
Output Power RMS
Output Power Max
Lowpass Filter
Subsonic Filter
Phase Shift
Bass Boost
Operating Voltage
Fuse Rating
Dimensions (B x H x L)
20 cm (8“)
20 cm (8“)
1 x 200 W
1 x 400 W
50 – 150 Hz @ 12/18dB/Octave
Fixed at 15 Hz
0° / 180°
0 – 12 dB @ 45 Hz
+12 V (9 – 15 V), negative ground
25 A
280 x 140 x 520 mm
IMPORTANT NOTES PRIOR TO INSTALLATION
• This device is only suited for a 12 volt system with negative ground.
• The radiated heat while operation requires sufcient air circulation at the place of installation. It is very im-
portant that the heat sink ns do not have contact with any metal parts or any surfaces which could impair
air circulation. The amplier may not be installed in small closed location or spaces without air circulation.
We recommend the installation in the vehicle’s trunk. Ensure sufcient protection against vibrations, dust
and dirt.
• Ensure that the input and output cables are sufciently separated from the power supply cables. Otherwise
interferences may occur.
• Ensure the accessibility of the fuse and the operating elements after installation.
• The reliability and performance of the amplier depends on the quality of installation. Preferably consult an
expert to install the system.
• Avoid any damage or removing of the components of the vehicle like wires, cables, board computer, seat
belts, gas tank or the like.