________________________________________________________________________________
10 www.hightechpet.com High Tech Pet Products, Inc.
Installing / Replacing the Battery Pack
The replaceable battery pack installs at the bottom of the unit, between
the Shock Probes. Note that there is a small tongue on the battery pack
that lines up with a groove in the collar casing. This is to ensure that the
battery pack is installed correctly. Line up the tongue with the groove and
push rmly. You will hear two clicks as the battery pack snaps into place.
To remove the battery pack, squeeze together the two nger tabs on each
side of the battery pack and pull it out of the casing.
Replacement B-3V8 battery packs are available at www.hightechpet.com.
This popular battery is also used with other High Tech Pet products.
Battery Life
The custom 8-cell battery pack will last two about months when few cor-
rections are generated, and about two weeks during the initial training
when a lot of corrections are generated.
Battery life is extended if you disengage the battery when it is not being
used. To do this squeeze together the two nger tabs on each side of
the battery pack and pull it out of the casing about 3/16 inch. Friction will
retain the battery in the disengaged position as shown here.
When the battery is disengaged, pressing the TEST button will produce
no tone or status lights.
Engaged (tab is in)
Disengaged (tab is out)
To Next Page
Loading...
