Rev. II – 1/29/2013 ms-5-pet-collar-manual
High Tech Pet Products, Inc.
2476 Palma Drive, Suite A
Ventura, CA 93003
www.hightechpet.com
MAINTAINING THE WATERPROOF SEAL
The waterproof seal will last for years if you keep the gasket
clean when replacing the battery. Here are some suggestions for
e xtending the life of your collar.
• Clean the bottom edge of the collar before opening the case to
replace a battery. Also thoroughly dry the collar before opening
it. A blow dryer can be used.
• After opening the case, clean any visible dirt off the inside lip of
the case and the gasket on the bottom cover. Finally blow off any
remaining lint or bers. Then insert the battery and close it up.
• Keep the inside of the collar dry. Each time you open it look for
water or moisture inside. If detected, remove the battery and
use a blow dryer on the circuit board.
To Previous Page