To Next PageTo Next PageWhat to do if my Highlight Synergy 0.5 machine does not power up?
If your Highlight Packaging equipment machine isn't powering up, here's what you should check: 1. Ensure the machine is properly plugged into a 120VAC, 15A outlet. 2. Verify that the Power Switch is turned on. 3. Check the main circuit breaker; turn it back on, or replace it if needed.
Why is the display on my Highlight Packaging equipment Frequency Drive not on?
If the display on your Frequency Drive isn't on, the cause may be: * The drive circuit breaker is off. In this case, turn the breaker back on, or replace it if necessary. * The drive has malfunctioned. Check the wiring to the Frequency Drive, or replace it if necessary.
Discusses safety symbols and warnings for safe operation.
Provides overview and terms of product warranty.
Explains the manual's purpose, audience, and scope.
Details procedures for obtaining technical support.
Lists changes and updates made to the manual.
Lists physical measurements of the machine.
Details electrical requirements and components.
Illustrates the machine's main components and layout.
Guides on selecting and preparing the machine's location.
Outlines steps for initial machine setup and unpacking.
Covers configuration and settings for the AC frequency drive.
Details the keypad and display of the Altivar 12 drive.
Explains navigation within the drive's parameter menus.
Lists parameters for monitoring drive status and performance.
Details programmable functions and parameters for the drive.
Lists parameters specifically within the drC menu section.
Lists parameters specifically within the CtL menu section.
Lists parameters specifically within the FUn menu section.
Explains the diagnostic system and troubleshooting fault codes.
Details essential settings before initial machine operation.
Describes how to test film force against product for secure wrapping.
Information on configuring and using the optional scale package.
Lists suggested configuration values for the scale.
Step-by-step guide for calibrating the scale.
Step-by-step guide for loading film onto the carriage.
Basic instructions for operating the machine's turntable.
Procedures for standard film cutting after wrapping.
Outlines regular maintenance tasks for longevity and performance.
Details lubrication frequency for turntable bearings.
Instructions for draining and replacing oil in gear reducers.
Guidance on inspecting and maintaining sprockets and chains.
Lubrication advice for other bearings.
Provides a scheduled overview of maintenance tasks.
General guidance for diagnosing and resolving machine issues.
Addresses common issues related to machine power supply.
Covers troubleshooting steps for turntable operation failures.
Lists recommended spare parts for the machine.
Provides technical drawings of machine components.
Includes electrical schematics and enclosure layouts.
Lists programming parameters for the Altivar 12 drive.
Details the layout and components within the electrical enclosure.
General| Brand | Highlight |
|---|---|
| Model | Synergy 0.5 |
| Category | Packaging equipment |
| Language | English |
