HIK VISION DS-K4H250 Series User Manual

Title:
DS-K4H250/450/258 series magnetic lock
connect to DS-K2800 series Access Controller
Version:
v1.0
Date:
01/11/2018
Product:
Access Control Device
Page:
1 of 9
DS-K4H250/450/258 series magnetic lock connect to DS-
K2800 series Access Controller
Preparation
Connecting magnetic lock to access controller is mainly applied to swiping card to open the door for
exiting. For magnetic lock and access controller in this document, please check the table below:
Magnetic Lock
Access Controller
DS-K4H250S
DS-K4H250D
DS-K4H450D
DS-K2801
DS-K2802
DS-K2804
DS-K4H258S
DS-K4H258D
Note
This document is simply used to guide users how to wire correctly and ensure access controllers can
control locks.
The access controller model in this document is DS-K2804.
Part 1 is mainly for magnetic lock wiring, and Part 2 and Part 3 are mainly for the situation that users
could get the door status on iVMS-4200 Client.
Notice
1. Please cut off power supply before wiring;
2. Please use a tool to screw magnetic lock screws in following picture, and remove the cover of
magnetic lock, find V+/V- and NO/NC & COM interfaces of magnetic lock in following picture;

HIK VISION DS-K4H250 Series Specifications

General

Brand	HIK VISION
Model	DS-K4H250 Series
Category	Controller
Language	English

Summary

Preparation and System Overview

Part 1: Lock+ & Lock- Wiring

Part 2: Lock+/Lock- & NC/COM Wiring

DS-K4H250S Wiring

Wiring instructions for the DS-K4H250S magnetic lock.

DS-K4H250D/DS-K4H450D/DS-K4H258D Wiring

Wiring for DS-K4H250D, DS-K4H450D, and DS-K4H258D models.

Part 3: Lock+/Lock- & NO/COM Wiring

DS-K4H250S Wiring

Wiring instructions for the DS-K4H250S magnetic lock.

DS-K4H250D/DS-K4H450D Wiring

Wiring instructions for DS-K4H250D and DS-K4H450D models.

iVMS-4200 Client Configuration and Verification

Add Access Controller to iVMS-4200

Procedure to add the access controller to the iVMS-4200 client software.

Device Arming Control

Checking the access controller's arming status via iVMS-4200.

Access Control Parameters Setup

Configuring door magnetic sensor and other parameters in iVMS-4200.

Door Status Monitoring

Verifying door status and magnetic lock LED status in iVMS-4200.