HIK VISION DS-K4H258D - User Manual

Title:
DS-K4H250/450/258 series magnetic lock
connect to DS-K2800 series Access Controller
Version:
v1.0
Date:
01/11/2018
Product:
Access Control Device
Page:
1 of 9
DS-K4H250/450/258 series magnetic lock connect to DS-
K2800 series Access Controller
Preparation
Connecting magnetic lock to access controller is mainly applied to swiping card to open the door for
exiting. For magnetic lock and access controller in this document, please check the table below:
Magnetic Lock
Access Controller
DS-K4H250S
DS-K4H250D
DS-K4H450D
DS-K2801
DS-K2802
DS-K2804
DS-K4H258S
DS-K4H258D
Note
This document is simply used to guide users how to wire correctly and ensure access controllers can
control locks.
The access controller model in this document is DS-K2804.
Part 1 is mainly for magnetic lock wiring, and Part 2 and Part 3 are mainly for the situation that users
could get the door status on iVMS-4200 Client.
Notice
1. Please cut off power supply before wiring;
2. Please use a tool to screw magnetic lock screws in following picture, and remove the cover of
magnetic lock, find V+/V- and NO/NC & COM interfaces of magnetic lock in following picture;

HIK VISION DS-K4H258D Specifications

General

Brand	HIK VISION
Model	DS-K4H258D
Category	Controller
Language	English

Summary

Preparation and Safety

Initial Wiring Precautions

Safety guidelines and initial checks before wiring magnetic locks to access controllers.

Part 1: Lock+ & Lock- Wiring

DS-K4 H250 S & DS-K4 H258 S Wiring

Connect DS-K4H250S and DS-K4H258S magnetic locks using Lock+ and Lock- terminals.

Part 2: Lock+;Lock- & NC;COM Wiring

DS-K4 H250 S Wiring with NC;COM

Detailed wiring for DS-K4H250S magnetic locks using NC/COM for door status monitoring.

DS-K4 H250 D & DS-K4 H450 D Wiring

Wiring DS-K4H250D and DS-K4H450D magnetic locks using NC/COM interfaces.

Software Configuration and Status Monitoring

Adding Access Controller to iVMS-4200

Guide to adding the access controller to the iVMS-4200 client software.

Access Control Parameters Setup

Configure door magnetic sensor and exit button type in access control parameters.

Door Status and Alarm Event Monitoring

Check door status and alarm events on iVMS-4200 client and magnetic lock LED status.

Part 3: Lock+;Lock- & NO;COM Wiring

DS-K4 H250 S Wiring with NO;COM

Wiring DS-K4H250S magnetic locks using NO/COM interfaces.

DS-K4 H250 D & DS-K4 H450 D Wiring with NO;COM

Connect DS-K4H250D and DS-K4H450D magnetic locks using NO/COM interfaces.