Title:

DS-K4H250/450/258 series magnetic lock

connect to DS-K2800 series Access Controller

Version:

v1.0

Date:

01/11/2018

Product:

Access Control Device

Page:

1 of 9

DS-K4H250/450/258 series magnetic lock connect to DS-

K2800 series Access Controller

Preparation

Connecting magnetic lock to access controller is mainly applied to swiping card to open the door for

exiting. For magnetic lock and access controller in this document, please check the table below:

Magnetic Lock

Access Controller

DS-K4H250S

DS-K4H250D

DS-K4H450D

DS-K2801

DS-K2802

DS-K2804

DS-K4H258S

DS-K4H258D

Note

This document is simply used to guide users how to wire correctly and ensure access controllers can

control locks.

The access controller model in this document is DS-K2804.

Part 1 is mainly for magnetic lock wiring, and Part 2 and Part 3 are mainly for the situation that users

could get the door status on iVMS-4200 Client.

Notice

1. Please cut off power supply before wiring;

2. Please use a tool to screw magnetic lock screws in following picture, and remove the cover of

magnetic lock, find V+/V- and NO/NC & COM interfaces of magnetic lock in following picture;

HIK VISION DS-K4H258D - Page 9

Other manuals for HIK VISION DS-K4H258D