Hiking DDS238-4 W User Manual

But this ways is only for 1 pcs meter to connection on RS485 wire
10. Display item
1
．
Please scan the two-bar-codes to download the “WISEN” software
插入二维码
二
. Meter input power
When the meter power on , you can push the setting button last 5s , meter enter into the status of
waiting for WIFI distribution network and the WIFI led will flash 1s interval .
its means meter enter into the status of waiting for WIFI distribution network . if WIFI led light on
5s , light off 0.1s ,it means meter connect the WIFI successfully.
二
. Add device
Please check firstly that your telephone have connected the available WIFI network , then click
the “add device “ button .now the meter only used under 2.4GHz WIFI network , it can not use
under 5GHz WIFI network .
INFORMATION LCD DISPLAY
01
Impulse imp/kWh C 0000
02
Total energy kWh 000000.00
03
Positve kWh 00000.00
04
Reverse kWh -00000.00
05
Reset energy EP0000.00
06
Real voltage V U 000.0
07
Real current A A 00.00
08
Real active power W P 0.0
09
Real reactive power Var P 0.0
10
Power factor COSФ PF 0.00
11
Real frequency Hz F 00.00
12
Meter serial high 6 digits H 000000
13
Meter serial low 6 digits L 000000
14
MODBUS ID 001

Hiking DDS238-4 W Specifications

General

Brand	Hiking
Model	DDS238-4 W
Category	Measuring Instruments
Language	English