Handheld Thermal Monocular Camera User Manual
4
Chapter 2 Preparation
2.1 Charge Device
After the device starts up, the OSD (on-screen display) shows the battery status. When the battery
is low, charge the device and ensure it works properly.
Before You Start
● The charging temperature should be from 0 °C to 45 °C (32 °F to 113 °F).
● Charge the device with the delivered cable.
Steps
1. Lift the cable interface cover.
2. Plug in the cable and charge the device.
Figure 2-1 Cable Interface
● Flashing Red & Green: error occurred.
● Solid Red: battery is properly charged.
● Solid Green: battery is fully charged.
● OFF: battery is not charged.
2.2 Power On/Off
Power On
To Next Page
Loading...
