What to do if the switch can’t be pulled on HIKOKI WH36DB Impact Driver?
If the switch can’t be pulled on your HIKOKI Impact Driver, it might be because the forward/reverse selector button is positioned halfway. Press the button firmly into position for the desired direction of rotation.
Why HIKOKI WH36DB Impact Driver doesn't start charging USB device when charging battery and USB device at the same time?
This is not a malfunction. When the battery capacity reaches a certain level, USB charging automatically begins.
Why does HIKOKI WH36DB pause USB charging when charging battery and USB device at the same time?
This is not a malfunction. The charger pauses USB charging for about 5 seconds while it checks whether the battery has successfully completed charging.
Why does HIKOKI WH36DB pause USB charging midway?
This is not a malfunction. The charger pauses USB charging for about 5 seconds when it is differentiating between power sources.
How to check charging status of USB device on HIKOKI WH36DB?
Examine the USB device that is charging to confirm its charging status.
Why HIKOKI Impact Driver USB power lamp does not switch off?
This is not a malfunction. The USB power lamp lights up green to indicate that USB charging is possible.
Why did HIKOKI Impact Driver USB power lamp switch off?
If the USB power lamp has switched off and the USB device has stopped charging on your HIKOKI Impact Driver, the battery’s capacity may be low. Replace the battery with one that has capacity remaining. Also, ensure the charger’s power plug is plugged into an electric socket.
Why HIKOKI Impact Driver makes a high-pitched noise when trigger is pulled?
If an abnormal high-pitched noise occurs when the trigger switch is pulled on your HIKOKI Impact Driver, it's likely because the trigger switch is only being pulled slightly. This is not a malfunction and won't occur if the trigger switch is pulled more fully.
Why is HIKOKI Impact Driver battery usage time short?
If the battery usage time is short even though the battery is fully charged on your HIKOKI Impact Driver, the battery’s life may be depleted. Replace the battery with a new one.
Why did my HIKOKI WH36DB Impact Driver suddenly stop?
If your HIKOKI Impact Driver suddenly stops, it could be due to several reasons. First, the tool might be overburdened, so try to eliminate the cause of the overburden. Second, the battery could be overheated; in this case, allow the battery to cool down. Finally, the motor may have automatically stopped to prevent tool failure if the trigger switch was held down for 5 minutes or longer. This is not a malfunction.
General| Voltage | 36V |
|---|---|
| Chuck Type | 1/4" Hex |
| Battery Type | Li-ion |
| Impact Rate | 0-4, 000 ipm |
| Weight | 1.7 kg |
| Blows Per Minute | 0 - 4, 000/min |
To Next Page