Why does HIKOKI Impact Driver battery take a long time to charge?
If the battery takes a long time to charge on your HIKOKI Impact Driver, the temperature of the battery, the charger, or the surrounding environment may be extremely low. Try charging the battery indoors or in a warmer environment. Also, ensure the charger’s vents are not blocked. If the cooling fan is not running, contact a HiKOKI Authorized Service Center for repairs.
Why battery cannot be installed in HIKOKI Impact Driver?
If the battery cannot be installed in your HIKOKI Impact Driver, it may be because you are attempting to install a battery other than that specified for the tool. Please install a multi volt type battery.
Why is HIKOKI Impact Driver charge indicator lamp blinking red?
If the charge indicator lamp blinks red and battery charging doesn’t begin on your HIKOKI Impact Driver, make sure the battery is fully inserted. If that doesn't work, the battery may be overheated. Allow the battery to cool down. If left alone, the battery will automatically begin charging once its temperature decreases, although this may reduce battery life. It’s best to cool it in a well-ventilated area away from sunlight before charging.
What to do if HIKOKI WH36DB Impact Driver charge indicator lamp flickers purple?
If the charge indicator lamp rapidly flickers purple and battery charging doesn’t begin on your HIKOKI Impact Driver, ensure the battery is fully inserted. Also, check for and remove any foreign matter in the battery terminal or where the battery is attached.
Why tool bits can’t be attached to my HIKOKI Impact Driver?
If tool bits can’t be attached to or fall off of your HIKOKI Impact Driver, it may be because the shape of the attachment portion doesn’t match. Use a bit with a hexagonal shaft that has a width across flats of 6.35 mm. If you are using an L-type tool bit, replace it with an S-type bit.
What to do if screw head slips with HIKOKI WH36DB Impact Driver?
If the screw head slips or comes loose when using your HIKOKI Impact Driver, ensure that the bit number matches the screw size by installing a suitable bit. If the bit is worn, replace it with a new one.
How to fix HIKOKI WH36DB Impact Driver that doesn't run?
If your HIKOKI Impact Driver doesn’t run, it could be due to a lack of battery power, so charge the battery. Alternatively, the safety function may have been activated if the trigger switch was held down while the battery was inserted. Release the trigger switch and pull it again to make the tool run.
General| Voltage | 36V |
|---|---|
| Chuck Type | 1/4" Hex |
| Battery Type | Li-ion |
| Impact Rate | 0-4, 000 ipm |
| Weight | 1.7 kg |
| Blows Per Minute | 0 - 4, 000/min |
To Next Page