VC2000 Series Vision Controller User Manual
2
Otherwise, there is a danger of electric shock.
●
This is a Class A device. In the living environment, this device may cause radio
interference. In this case, the user may be required to take practical measures against the
interference.
●
Make sure that the device is installed in good condition, the wiring is firm, and the power
supply meets the requirements before powering on the device.
●
Avoid powering off the device by plugging and unplugging the power cord directly if the
device has a power switch.
●
If the device emits smoke, odor or noise, please turn off the power and unplug the power
cord immediately, and contact the dealer or service center in time.
●
It is strictly forbidden to touch any terminal of the device when operating it. Otherwise
there is a danger of electric shock.
●
It is strictly forbidden for non-professional technicians to detect signals during device
operation, otherwise it may cause personal injury or device damage.
●
It is strictly forbidden to maintain the device is powered on. Otherwise, there is a danger
of electric shock.
●
If the device does not work properly, please contact your dealer or the nearest service
center. Never attempt to disassemble the device yourself. We shall not assume any
responsibility for problems caused by unauthorized repair or maintenance.
●
Caution: If the device has battery, risk of explosion if battery is replaced by an incorrect
type. Dispose of used batteries according to the instructions.
●
Please dispose of the device in strict accordance with the relevant national or regional
regulations and standards to avoid environmental pollution and property damage.
Note
●
Check whether the device's package is in good condition, whether there is damage,
intrusion, moisture, deformation, etc. before unpacking.
●
Check the surface of the device and accessories for damage, rust, bumps, etc. when
unpacking.
●
Check whether the quantity and information of the device and accessories are complete
after unpacking.
●
Store and transport the device according to the storage and transport conditions of the
device, and the storage temperature and humidity should meet the requirements.
●
It is strictly prohibited to transport the device in combination with items that may affect
or damage the device.
●
Quality requirements for installation and maintenance personnel:
○
Qualification certificate or working experience in weak current system installation and
maintenance, and relevant working experience and qualifications. Besides, the
personnel must possess the following knowledge and operation skills.
○
The basic knowledge and operation skills of low voltage wiring and low voltage
electronic circuit connection.
○
The ability to comprehend the contents of this manual.
●
Please read the manual and safety instructions carefully before installing the device.
●
Please install the device strictly according to the installation method in this manual.
●
The case of the device may be overheated, and it needs to be powered off for half an hour
To Next Page
