HIKVISION 1200KI User Manual

1 How to use 485 control back-end GUI4.0
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
How to use 1200KI & 1006KI 485 control back-end GUI4.0
This document is intended to introduce the method of how to use 1200KI & 1006KI 485
control back-end GUI4.0 (NVR version 4.21.000 is recommended). We will start from hardware
connection
1. Connect keyboard RS-485 to back-end KB interfaces, T+ to D+, T- to D- through twisted pair.
Note only back-end with KB interface on rear panel could be controlled by 485 keyboard
(485 interface on NVR/DVR is for backend to control analog PTZ)
2. Configure Back-end Device No, this number ranges from 0-255( 0 is not recommended, it
mean control all), you can configure on backend GUI or web interface
3. Login keyboard, use FOCUS+/A button to switch between number, capital and lower case
letters. (You can choose remember password on your next login)

HIKVISION 1200KI Specifications

General

Video Compression	H.265+/H.265/H.264+/H.264
Working Humidity	10% to 90%
Category	NVR
Channels	16
Network Interface	1 RJ-45 10/100/1000 Mbps self-adaptive Ethernet interface
USB Interface	USB 2.0
HDMI Output	1 HDMI output
VGA Output	1 VGA output
Audio Output	1 RCA audio output
Two-Way Audio	Yes
Decoding Format	H.265/H.264
Working Temperature	-10 °C to 55 °C (14 °F to 131 °F)
Type	16 PoE 4K NVR