Video Wall Controller • User Manual
26
Click NTP.
Fill in the Server Address and NTP port.
The server address is the IP address or the domain name of the NTP server.
Click Save.
RS-485/RS-232 is used to access control signals.
Use RS-485 cable to connect the device to the computer or the terminal.。
Enter Configuration → System → System Settings → Serial Port Configuration.
Set Serial Port Parameters
Set the RS-485 / RS-232 parameters according to the requirement. Please keep the
parameters of the device consistent with those of the computer or the terminal.
Click Save.
It is used to set the font of OSD and subtitles. The default font can be used. Enter Configuration →
System → System Settings → Font Configuration, click Browse to import a new font according to
the requirement.
To Next Page
Loading...
