HIKVISION C30 Series - Diagnosis; Set Syslog

Video Wall Controller • User Manual
29
Set Diagnosis
Configure the syslog server. When the device generates logs, upload the logs to the syslog server.
Please complete the deployment and configuration of the syslog server first.。
Enter Configuration → System → Maintenance → syslog.
Set syslog
Check Enable syslog.
Set server parameters.
 Server IP: The IP address of the syslog server.
 Port: The port of the syslog server.
 Upload Cycle: it is used to set the log upload cycle in hours.
 Protocol Type
− TCP and UDP: No device or server certificate verification is required.
− One-way authentication and two-way authentication: Device or server certificate
verification is required.
Click Save.
This part introduces how to add, edit and delete users of the device.